Tripleflow Filter Tap Fitting Instructions

Once the tap has been installed and connected to your normal hot and cold water supply, all you have to do is follow these easy steps:

Attach the clamp valve with the red tubing onto the cold water mains pipe under your sink.
Tighten the 2 screws to hold it in position.
Attach the filter head to the inside of the cabinet.
Plug the 2 plastic tubes into the filter head: red to the left and blue to the right.
Insert the cartridge into the filter head and twist, it is now locked into position.
Turn the handle on the clamp valve to make your connection and then unscrew again to allow the water to flow.
Turn on the tap and allow to run clear.
That's all you have to do ... It really is that simple !